CDA RC 9000 Users operating instructions Provozní pokyny stáhnout pdf (Strana 47)

Fig. 60

230 V

PEN

(L2)

Fig. 61

Electrical feeder cable connection

To connect the supply cable:

- Remove the screws securing the cover “A” on the rear of the cooker (fig. 60).

- Feed the supply cable through the cable clamp “D”. The supply cable must be of a

suitable size for the current requirements of the appliance; see the section “Feeder

cable section”.

- Connect the wires to the terminal block “B” as shown in the diagram in figure 61;

or connect the phase wires to the terminal block “B” and the earth wire to the

terminal PE as shown in figure 60.

- Take up any slack in the cable and secure with the cable clamp “D”.

- Replace the cover “A”.

Before effecting any intervention on the electrical parts of the appliance, the

connection to the network must be interrupted.

Feeder cable section type H05RRF

230 V 3 x 0,75 mm

Earth cable must be 2 cm longer than neutral and live cables.

The operations must be executed by a qualified technician.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52

Žádné komentáře

CDA RC 9000 Users operating instructions Provozní pokyny Strana 47