CDA HG7300 Servisní příručka stáhnout pdf (Strana 16)

Fastening the Installation Brackets

Each cooktop is provided with an installation kit including brackets and screws for fastening the top to fixture

panels from 2 to 4 cm thick.

– Turn the cooktop upside down and fasten the brackets “F" and "R” to the appropriate socket holes, without

tightening the screws “B” for the moment.

– Make sure that the brackets are fastened as shown in figures 16a, 16b and 16c.

Fastening the Cooktop

– Insert the cooktop into the hole and position it correctly.

– Adjust the position of the brackets “F" and "R” and tighten screws “B” to block the cooktop firmly in position.

– With a sharp cutter or trimmer knife trim the excess sealing material around the edge of the cooktop.

Take care not to damage the workbench.

Fig. 16a

20 mm min.

40 mm max.

20 mm min.

40 mm max.

Front sideRear side

Fig. 16cFig. 16b

Front side

Rear

side

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Žádné komentáře

CDA HG7300 Servisní příručka Strana 16