CDA HG9320 Servisní příručka stáhnout pdf (Strana 12)

Fastening the Installation Brackets (ﬁg. 15)

– Each hob is provided with an installation kit including brackets and screws for fastening the top to ﬁxture

panels from 2 to 4 cm thick.

– Turn the hob upside down and fasten the brackets “A” to the appropriate socket holes, without

tightening the screws “B” for the moment (ﬁg. 16).

– Make sure that the brackets are fastened as shown in ﬁgure 15.

Fastening the Hob (ﬁg. 16)

– Spread the sealing material “C” out along the ﬁxture hole, making sure that the junctions overlap at the

corners.

– Insert the hob into the hole and position it correctly.

– Adjust the position of the brackets “A” and tighten screws “B” to block the hob ﬁrmly in position.

– With a sharp cutter or trimmer knife trim the excess sealing material around the edge of the hob. Take

care not to damage the benchtop.

Fig. 15

Fig. 16

20 mm min.

40 mm max.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Žádné komentáře

CDA HG9320 Servisní příručka Strana 12