CDA 3S10 Specifikace

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HYT : 01949 862 012 F : 01949 862 003 E : cu

10The LED and Neon LampsThe LED lamps (3S10BL) and neon light tubes (3S10WH) are long-life items that are not designed to be replaced by the user. In

11• The wire which is coloured green and yellow must be connected to the terminal marked “E” (Earth) or coloured green.• The wire which is coloure

12Mounting Your ExtractorThis appliance is designed to recirculate air only, under no circumstances should it be connected to any ductwork or external

13Installation1. Thread the safety cable upward through the small hole in the ceiling plate then downward through the centre boss. Pull this tight

142. Remove the chrome cover from the top of the sphere, then remove and discard the cylindrical packing piece from the top bracket within it (Fig. 8

156. Select the smaller diameter hanging tube and pass it through the ceiling rose cover. Note that the end of the hanging tube with holes in it nee

16Fig. 16Fig. 17Fig. 1910. With a second person supporting the weight of the sphere, thread the safety cable down the tube assembly (Fig. 16) so it

1711. With an assistant supporting the weight of the sphere, adjust the height by sliding the outer hanging tube up or down the inner one (Fig. 20).1

18Notes:

19E & O E. All instructions, dimensions and illustrations are provided for guidance only. CDA reserve the right to change specifications without

2ImportantThe CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note th

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HYT : 01949 862 012 F : 01949 862 003 E : cu

3IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2002/96/EC.At the end of its working life, the product must

4Using your ExtractorRemote Control A - LED lightsB - “Plus” buttonC - “Light” buttonD - “Power” buttonE - “Clock” buttonF - “Minus” b

5To switch the extractor on or o: • Press the “Power” button “D” once. After switching on the motor will automatically start at the lowest speed s

6Care and MaintenanceIMPORTANT : DO NOT PERFORM MAINTENANCE OR CLEANING OF THE EXTRACTOR WITHOUT FIRST SWITCHING OFF THE ELECTRICITY SUPPLY.Cleaning Y

7To remove the aluminium grease filters for cleaning• While supporting the weight of the lower half of the globe, use the special tool supplied with

8Changing the charcoal filter (Filter part number CHA30)To ensure best performance of your extractor, you should replace the charcoal filter every four

9If your extractor is not working:1. Check that the mains supply has not been switched o.2. Check that the fuse in the spur has not blown.3. There