CDA CTE Series Uživatelský manuál stáhnout pdf (Strana 8)

Mounting your Extractor

This extractor is designed to be installed within a bridging

unit and is not suitable for direct wall mounting. To install

the product, proceed as follows: -

1. Prepare the bridging unit by installing a shelf inside the

unit 135mm above the base of the unit. This shelf must

have a venting hole cut out to allow the extracted air to be

exhausted. This venting hole should be cut according to the

dimensions shown in ﬁgure 6.

2. The extractor is intended to be mounted ﬂush with the

decor door ﬁtted to the bridging unit. To achieve this,

adjust the depth of the cutout by an amount equal to the

difference between 25mm and the thickness of the decor

door. For example, a decor door 18mm thick would require a

cutout of 250 + (25-18) = 265 mm.

3. Remove the grease ﬁlters as described on page 4,

then mount the extractor to the bridging unit using six

appropriate wood screws (not supplied) in the locations

shown in ﬁgure 6.

4. You can choose to use this extractor in either extraction

or recirculation mode. The options for this are shown in

ﬁgure 7.

Fig. 4

Fig. 7

External Exhaustion Internal Recirculation

135mm

Hole for vent ducting of

minimum 125mm diameter

Partition

wall

Hole for vent

ducting of

minimum

125mm diameter

Fig. 5

Fig. 6

227

600

DIA 120mm

270

290

Partition

panel

514

258 + x

Rear Wall

168

300

DIA 125mm

1 2 3 4 5 6 7 8 9 10 11

Komentáře k této Příručce

Žádné komentáře

CDA CTE Series Uživatelský manuál Strana 8

Komentáře k této Příručce

Související produkty a manuály pro Pračka CDA CTE Series